For Thrust Collars,
Trunnion Roller Shafts & Liners,
and Roller Mill Bearings
[HTL-440] [HTL-440G]
[TLA] [HTL-220 & HTL-320]
HTL-440
HTL Synthetic Series lubricants have been designed
to lubricate and prevent extreme loading and high temperatures. For trunnion roller shafts and
liners, thrust collars and roller mill bearings.
-
Water washable, hot or cold.
-
Non-Hazardous.
-
Extremely stable Flat viscosity vs.Temperature curve.
-
Withstands shaft temperatures to 500 F. (260C)
-
Operates without Water Jackets Successfully.
-
Lower maintenance costs.
-
No sludge or varnish.
-
Runs much cooler even under high loads.
-
Allows ample time to remedy mechanical problems.
HTL-440G
The HTL-440G is chemically similar to HTL-440 with the
addition of a micronized synthetic graphite for adverse operating conditions.
-
Will
provide protection during boundary conditions.
-
The graphite gives added protection against
direct contact of shaft and liner, preventing most shut downs.
-
Operates up to 20% cooler than HTL-440.
TLA - Trunnion Lubricant Additive
An additive that enhances the existing properties of
your petroleum based trunnion roller lubricants, properties such as: corrosion inhibiting,
anti-wear and extreme pressure properties.
-
Reduces friction.
-
Cooler operating temperatures.
-
Increased corrosion inhibiting, anti-wear and extreme
pressure properties.
-
Extends lifespan of lubricant (longer drain intervals).
TLA-G
TLA-G uses the same formulation as TLA with the
addition of a micronized synthetic graphite for extreme operating conditions.
-
Adds extra protection for your
shaft & liner during extreme operating conditions
-
Prevents unnecessary shut downs.
HTL-220 & HTL-320
Ask About Our HTL-220 & HTL-320 (also available as HTL-220G for pressurized
pumping systems and as HTL-320G for non-pressurized pumping systems)
Specifically Designed For Ball Mills, Rod Mills and
Rotary Crushers With All The Advantages of Our HTL Series
|
